VER-T-LIFT PICTURES VER-T-LIFT CLIPS VER-T-LIFT TRAILER

VER-T-LIFT Confined Space and Lifting Device Please note:   The VER-T-LIFT is a patent pending product. Click to enlarge Click to enlarge Click to enlarge In the pictures above, the Ver-T-Lift is being used as both a confined space safety device while the employee is in the manhole and also to raise and lower equipment and materials into the manhole. With the dual winch line attachments on the lifting arm, you can use multiple winches, one to attached to the harness while the employee is in the manhole and another to attach to the equipment (jackhammer) or to the material being lowered and raised (bucket of lining material). Note that the employee is raised completely out of the manhole, unlike the tripod style where you can only raise the employee partially out of the manhole. Click to enlarge Click to enlarge Click to enlarge In the pictures above, ODT is removing three (3) pump motors for Cameron University in Lawton, Oklahoma.  Each motor weighed approximately 600 pounds.  Because of the orientation of the room, the motors were right up against the wall and there is grating on the accessible side of the motors which kept them from being rolled out once they were removed. ODT set the Ver-T-Lift up inside the room, hooked the Saf-T-Lift to the motor and raised the motor up. With the swiveling arm, the motor swung above the pipes and was lowered to the floor.  There was little to no physical effort in the removal of these motors and the complete operation took approximately two (2) hours. Ver-T-Lift lowering 800 lb motor from 4 story building Ver-T-Lift is tied back to center of building The Ver-T-Lift with the roof top attachment is used to lower an 800 pound motor off the top of this 4 story hospital.  This total operation took approximately 2 hours. Click on image to enlarge Click to enlarge Click to enlarge The roof top model of the Ver-T-Lift was used to lift a solid wood table weighing approximately 300 pounds to the 3rd floor deck.  The front legs were not used in order to allow the arm to reach out over the edge of the building and lift the table up and swing it over to the deck area. The strength and versitility of the Ver-T-Lift changed an impossibility into a reality for a very good friend and made her very happy! Ver-T-Lift used on flood plain manhole The Ver-T-Lift can be used without the back legs, a locking bar is used to keep the arm from swiveling past the midway point.  The Ver-T-Lift can be used to remove the manhole lid and for confined space entry/fall protection on flood plain manholes, there is no other device like the Ver-T-Lift on the market!  The lifting arm extends to 14 feet and with the optional extension kit, it will extend to 20 feet.   Ver-T-Lift Specifications: Constructed of high tinsel aluminum 10,000 pound strength at any attachment point Designed to support safe working load of 4,000 pounds System meets/exceeds ANSI & OSHA requirements and is certified by two (2) Professional Engineers Constructed using quick release pins/rods to be quickly assembled and disassembled in the field Each unit is identified by serial number Designed to be maintenance free and to be easily upgraded Pulley system is high tinsel aluminum with bronze bushings The swivel at the fulcrum point is made from space age technology using a nylon, self lubricating bushing Can be used with many types of winches and accessories and can be used with one or more winches Retrieval arm has the ability to rotate 360 degrees and has a safety locking attachment to lock arm in place Optional retrieval arm is 36 inches long and extends out of a total of 48 inches Retrieval arm assembly extends up to a total of 20 feet in height with optional extension kit (14 feet without the extension kit) Portable/mobile for installation in any type terrain Has two dolly wheels attached to base for easy maneuverability (accessory) Leveling pods on all four legs Basic unit weighs approximately 185 pounds Can be used in very limited areas, confined spaces and high traffic areas Shall have reflective tape for safety Shall have a numbering system for assembly   Accessories: Ver-T-Lift Options: Ver-T-Lift Dolly Wheels & Handle Kit Ver-T-Lift Vertical Extension Kit Ver-T-Lift Extending Arm Ver-T-Lift Roof Top Attachment Winch Options: Miller Manhandler Hoist - 50' winch line - rated @ 350 lbs Sala 2-way Manual Winch Call today to receive a personal price quote!!